Attaching the Paper Support
Insert the paper support into the slots at the rear of the printer
as shown below.
Note:
To print on transparencies, you need to reposition the paper support
as described in ‘‘Loading Transparencies’’ on page 6-8.
Choosing a Place for the Printer
Follow the guidelines listed below when placing your printer.
q Place the printer on a flat, stable surface. The printer will
not operate properly if it is tilted or at an angle.
q Place the printer close enough to the computer for the
interface cable to reach it easily.
q Leave adequate room for easy operation and maintenance.
q Leave enough room on the table at the front of the printer
to lower the output tray.
C-4
2
R
EPSON Stylus Photo
User’s Guide
A5 size Chapter 2
12-28-96
Getting Started 2-3
To Next Page
Loading...
