Epson Stylus Photo - Installing the Ink Cartridges

Plugging in the Printer
1. Check the label on the back of the printer to make sure the
voltage required by the printer matches that of the
electrical outlet you will be plugging it into. Also, make
sure that you have the correct power cable for your power
source.
c
Caution:
It is not possible to change the printer’s voltage. If the
rated voltage and your outlet voltage do not match,
contact your dealer for assistance. Do not plug in the
power cord.
2. If the power cord is not attached to the printer, connect it to
the AC inlet on the back of the printer.
3. Plug the power cord into a properly grounded electrical
outlet.
Installing the Ink Cartridges
w
Warning:
The ink cartridges are self-contained units. Under ordinary
use, ink will not leak from a cartridge. If ink does get on your
hands, wash them thoroughly with soap and water. If ink gets
into your eyes, flush them immediately with water.
Install the ink cartridges as follows:
Note:
Do not open the ink cartridge packages until just before you install
the cartridges, or the ink may dry up.
2
R
EPSON Stylus Photo
User’s Guide
A5 size Chapter 2
12-28-96
Getting Started 2-5