Epson Stylus Pro 10000 - Page 136

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 129
3. Remove front four white screws, then remove the Paper Guide L.
Figure 4-31.
Tape
Screws
C A U T I O N
When installing Paper Guide L, insert all 5 tabs at top edge into
Sub-Platen slots and secure screws so that tabs do not protrude
above surface.
Figure 4-32.
If even one tab is not properly inserted, paper jams will occur
when paper is set. Roll paper can be properly fed but cutting
cannot be performed.
Sub platen
Paper Guide L
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com