Epson Stylus Pro 10000 - Page 153

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 146
9. Remove each two screws securing the Roller Unit (5 pieces), and remove the
Roller Unit from the Guide Unit.
Figure 4-68.
10. Remove ten screws (3x8), then push up the five Sub Platens and remove it. (Hooks
are in 2 places on the lower side.)
Figure 4-69.
11. Disconnect the cable connector connected to C362DRV Board CN42 and maintain
the slack at the left side surface as shown below.
Figure 4-70.
Screw
Screws
Sub Platen
With 1 place removed
A D J U S T M E N T
R E Q U I R E D
Carry out the justify with the L style gauge, when assemble the sub
platen. (Refer to Chapter 5 "Adjustment")
Cable
(slack)
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com