Epson Stylus Pro 10000 - Page 154

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 147
12. Remove twelve screws (M4x8) securing the Fan Duct and open the Fan Duct.
* Do not mind six screw of the upper sides are dropped inside the Fan Duct
without taking out.
Figure 4-71.
13. Open slowly the Fan Duct as shown below.
Figure 4-72.
C H E C K
P O I N T
The 6 screws of the upper side are hidden by the sponge seal, so
insert the screwdriver directly above the lower side screw positions
and remove the screws while confirming contact.
C A U T I O N
Pay attention so as not to fail the sponge seal with the driver.
(When it fails the air leakage occurs and the adsorption power of
the fan becomes low.) Remove the last screw while supporting with
the hand, because the fan duct falls when remove all the screw.
Do the cleaning, because dust etc. is adhering inside, when remove
the fan duct.
Screws
Screws
Fan Duct
Fan Duct
Left
Right
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com