Epson Stylus Pro 10000 - Page 159

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 152
7. Disconnect all head cables (6 pieces) from the Head Board.
Figure 4-84.
8. Remove one screw securing the Earth Plate. Do not drop the nut of the reverse
side.
Figure 4-85.
9. Disconnect three connector cables, while push down the upper side of the Head
Board.
Figure 4-86.
C A U T I O N
When connecting the FFC, firmly insert it directly in line. If the
connection fails due to angled insertion or insufficient insertion,
the following malfunctions could result.
1) Specified color will be emitted from all dots. (Poor contact.)
2) Specified color will not be emitted from all dots. (Blown
C362DRV Board fuse.)
C A U T I O N
When assembling, do not mistake the attachment location of the
tube and pipe.
Head cable
C A U T I O N
To avoid danger of circuit board failure and loose connection of
FFC cable, hold the upper part of the Head circuit board when
disconnecting the connector.
Nut
Screw
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com