Epson Stylus Pro 10000 - Page 160

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 153
10. Remove the screw of the upper side while holding down the Compression Spring
that is attached to the screw of the lower part with the finger such that the spring of
the hinge does not miss and not jump out, then remove the hinge, Compression
Spring and holder. Also remove the hinge on the right side.
Figure 4-87.
Figure 4-88.
11. Remove two screws securing the Printhead to the Head guide of the right and left.
Figure 4-89.
Hinge L
Spring holder
Screw (lower side)
Hinge RCompression spring
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com