Epson Stylus Pro 10000 - Removing the Cutter and Cutter Unit

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 160
4.3.3.6 Removing the Cutter and Cutter unit
1. Remove the R Side Cover.
2. Remove the two screws (CP(W): M3x6) securing the Carriage Cover and remove
the Carriage Cover.
Figure 4-105.
NOTE:
 When remove the cutter blade, take the following steps 3 to 4.
 When remove the cutter unit, take the following steps 5.
3. Push down and hold the Cutter Lever then pull up the solenoid and rotate it to the
arrow direction.
Figure 4-106.
4. Pulling up the Cutter from Cutter Unit.
Figure 4-107.
Carriage cover
Screw
Cutter
C A U T I O N
When installing cutter, be careful not to lose the cutter recovery
spring, which may spring out.
Cutter lever
Solenoid
Cutter
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com