Epson Stylus Pro 10000 - Removing the PF Motor ASSY

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Disassembly & Assembly Disassembly 166
4.3.3.11 Removing the PF Motor ASSY
1. Remove the L Side Cover as described in 4.3.1.5 "L Side Cover Removal".
2. Remove the Rear Cover as described in 4.3.1.7 "Rear Cover Removal".
3. Remove PF Motor Assy cable connector located near Power Supply Board.
Figure 4-119. PF Motor ASSY Cable Connector Removal
4. Loosen 4 screws (CP (W) M4x10) securing PF Motor bracket, then slide bracket
in direction of arrow shown in Figure 4-120 to loosen PF Motor timing belt
tension.
Figure 4-120.
5. Remove 2 screws securing PF Motor, then slide PF Motor to inner side to remove
it.
Figure 4-121.
PF Motor cable connector
Screws
Screws
PF Motor bracket
PF timing belt
Screws
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com