Epson Stylus Pro 10000 - CR Motor; PF Motor

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Adjustment Self-Diagnostics 257
5.4.8.1 CR Motor
Perform the CR motor reliability test.
The carriage runs with the round trip designated number at designated speed.
When the reliability number is [-1], reliability is repeated until key is input.
When the reliability number is [-1], the biggest count number is 99,999,999 times
(within 8 column), and the count become 0 in the case that this is exceeded.
Figure 5-93 showing the CR motor reliability test menu sequence.
Figure 5-93.

As for the parameter of CW, [240CPS], [300CPS], [400CPS] and [800CPS] are
possible select.
 As for the parameter of CCW, [240CPS], [300CPS], [400CPS] and [800CPS] are
possible select.
 The maximum value of the reliability number designation is [99,999,999 times].
 Carriage migration MAX location is 738.06 mm from the starting point location.
 Carriage migration MIN location is 111.05 mm from the starting point location.
 When the [Pause] key is pushed during the reliability test, the test can be broken.
5.4.8.2 PF Motor
Perform the PF motor reliability test.
The motor is actuated designated number.
When the reliability number is [-1], reliability is repeated until key is input.
When the reliability number is [-1], the biggest count number is 99,999,999 times
(within 8 column), and the count become 0 in the case that this is exceeded.
Figure 5-94 showing the PF motor reliability test menu sequence.
Figure 5-94.

The maximum value of the paper feed is [100.0mm].
 The maximum value of the reliability number designation is [99,999,999 times].
 When the [Pause] key is pushed during the reliability test, the test can be broken.
Enter
Speed CW : 240CPS
Speed CCW : 240CPS
Life Count
Count : 10
End : 50
Adjustable with "Paper Feed +/-" key.
Adjustable with "Paper Feed +/-" key.
Adjustable with "Paper Feed +/-" key.
Enter
Enter
Table 5-19.
Movement distance is less than
8.6mm
Movement distance is more than
8.6mm
Speed 25 CPS 52 CPS
Acceleration speed 0.1G 0.2G
Decrease speed 0.1G 0.2G
Enter
Enter
Enter
Feed Amount : 0.1mm
Life Count : -1
Count :10
End : 50
Adjustable with "Paper Feed +/-" key
at unit of 0.1mm.
Adjustable with "Paper Feed +/-" key.
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com