EPSON Stylus Pro 10000/10000CF/10600 Revision D
Maintenance Maintenance inspection items 272
(2) The guide rail department / Ink cartridge holder department (Refer to 4.2.3.7)
Figure 6-7.
Are not the ink tube and flat cable from the damper bracket department to guide
rail right edge of the print head department damaging it? Is there ink leakage also?
Are there the damage of ink leakage and ink tube in the coupling department from
the guide rail right edge?
Is there ink leakage in the coupling department on the ink cartridge holder?
Figure 6-8.
1.2 Waste ink tube : Are there a damage and ink leakage in the tube that is jointed to
the waste ink tank from the cleaning unit and flushing box?
(1) Cleaning unit (Refer to 4.2.3.12)
Are there ink leakage and damage in 3 ink tubes and thick tube?
Are 3 waste ink tubes fixed to the clamp on the flushing box?
Figure 6-9.
Is there sag (part that is low more the clamp location) in the waste ink tube
between the cleaning unit and flushing box?
Are 3 waste ink tubes plugged to the thick tube that is jointed to the waste ink tank
completely? (there is not sag and also the thick tube shall be lower than the clamp
location on a flushing box.)
(2) Flushing box
Is there ink leakage in the attachment department of the thick tube where is jointed
to the lower part of the flushing box?
Is not the filter inside the flushing box (new article is white) getting dirty and
clogging?
1.3 Waste ink tank : Remove the waste ink cover and confirm the following items.
(Refer to 4.2.3.1)
Guide rail
Clamp
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com
To Next Page
Loading...
