EPSON Stylus Pro 10000/10000CF/10600 Revision D
Maintenance Maintenance inspection items 276
Is there abrasion in the gear (aluminum) that is attached to the PF motor axis?
Figure 6-19.
Is not the piece of paper etc. adhering to the slowing-down gear?
Is the belt locatedding in the center of the slowing-down gear? (The belt is same
location even if the PF motor is revolved positive revolution or reverse
revolution.)
Figure 6-20.
4.2 PF roller : Confirm the PF roller in the condition which the paper release lever is
pulled in the front (unlock condition).
Are not the dirt of the ink and paper powder etc. adhering to the PF roller?
Is there ink dirt in the sub platen?
Figure 6-21.
Are not the dirt of the ink and paper powder etc. adhering to the PF driven roller
(Total of 128 pieces : each 4 pieces the installation to 32 holders)?
* Wipe the ink dirt with the cloth that wetted.
* Clean the paper powder with the brush.
Is not the dirt adhering to 3 support bearings of the PF rollers?
Figure 6-22.
Is not the dirt adhering to the PF loop scale?
PF motor axis / gear
CR driven pulley
Loop scale
Slowing-down gear
CR driven pulley
PF driven roller
PF roller
Support bearing
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com
To Next Page
Loading...
