EPSON Stylus Pro 10000/10000CF/10600 Revision D
Maintenance Maintenance inspection items 277
Is there the dirt of paper powder etc. in the Paper guide U?
Figure 6-23.
Are there the dirt of a cutter damage and paper powder etc. in the ditch periphery
department of the sub platen? (Refer to 4.2.3.2)
Is there ink dirt in the sub platen?
Is not the dust etc. clogged to the hole of the sub platen (vacuum hole)?
Are not the dirt and paper powder adhering to the sub platen?
Confirm whether there is not the adhesion etc. of a piece of paper in the next sensor /
encoder department. The dirt is removed with the air blower etc. in the case that the dirt
was discovered.
CR encoder (Refer to 4.2.3.5)
P_Edge sensor (Refer to 4.2.3.6)
PF encoder (Refer to 4.2.3.11)
Slide home sensor (Refer to 4.2.3.19)
CR_HP sensor (Refer to 4.2.3.21)
Paper release sensor (Refer to 4.2.3.22)
P_FRONT sensor (Refer to 4.2.3.23)
P_REAR sensor (Refer to 4.2.3.24)
P_THICK sensor (Refer to 4.2.3.27)
Shutter home sensor (Refer to 4.2.3.19)
Cap sensor (Cap / Pump unit)
Pressure sensor / Carriage locking sensor (Ink pump Assy)
Confirm whether the next switches are actuated with the open and close of the cover.
(It is not caught, and there is over throw.)
Front cover detection switch L/R
I/C holder cover switch
When the noise of the fan big or the form does not stick to Paper guide L2, remove the
dirt of 3 pieces of suction fan and periphery department in reference to 4.2.3.2.
5. Form conveyance path
6. Sensor / Encoder
Paper guide U
7. Cover open detection switch
8. Suction fan
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com
To Next Page
Loading...
