Epson Stylus Pro 10000 - Page 356

EPSON Stylus Pro 10000/10000CF/10600 Revision D
Stylus Pro 10600 Product Description 349
NOTE1: Roll paper width XX, Sheet width XX are as follows;
more than 1018mm~less than 210mm is classified into 10 categories at
100mm intervals.
NOTE1: Paper width in MENU P is the set paper width by ESC (S command.
If set paper is narrower than set paper width here, the set paper width
is used.
 Print mode
 Panel setup information
Paper ejection times of each paper size
(Sheet width 5)
P32 <nnnnnnnnn>
Print length of each paper size (Sheet width 6)
P33 <nnnnnnnnn>
Paper ejection times of each paper size
(Sheet width 6)
P34 <nnnnnnnnn>
Print length of each paper size (Sheet width 7)
P35 <nnnnnnnnn>
Paper ejection times of each paper size
(Sheet width 7)
P36 <nnnnnnnnn>
Print length of each paper size (Sheet width 8)
P37 <nnnnnnnnn>
Paper ejection times of each paper size
(Sheet width 8)
P38 <nnnnnnnnn>
Print length of each paper size (Sheet width 9)
P39 <nnnnnnnnn>
Paper ejection times of each paper size
(Sheet width 9)
P40 <nnnnnnnnn>
Print length of each paper size (Sheet width 10)
P41 <nnnnnnnnn>
Paper ejection times of each paper size
(Sheet width 10)
P42 <nnnnnnnnn>
Table 8-40. Paper information (MENU P)
Item Panel Display Setup Values
Table 8-41. Print mode (MENU M)
Item Panel Display Setup Values
Print mode setting times 1440-720 Uni-D
M1 <nnnnnnnnn>
Print mode setting times 720-720 Uni-D
M2 <nnnnnnnnn>
Print mode setting times 720-360 Uni-D
M3 <nnnnnnnnn>
Print mode setting times 360-720 Uni-D
M4 <nnnnnnnnn>
Print mode setting times 360-380 Uni-D
M5 <nnnnnnnnn>
Print mode setting times Others Uni-D
M6 <nnnnnnnnn>
Print mode setting times 1440-720 Bi-D
M7 <nnnnnnnnn>
Print mode setting times 720-720 Bi-D
M8 <nnnnnnnnn>
Print mode setting times 720-360 Bi-D
M9 <nnnnnnnnn>
Print mode setting times 360-720 Bi-D
M10 <nnnnnnnnn>
Print mode setting times 360-360 Bi-D
M11 <nnnnnnnnn>
Print mode setting times Others Bi-D
M12 <nnnnnnnnn>
Table 8-42. Panel setup information (MENU O)
Item Panel Display Setup Values
PG setting change times
O1 <nnnnnnnnn>
Roll paper margin change times
O2 <nnnnnnnnn>
Nozzle check patter print times
O3 <nnnnnnnnn>
Final nozzle check pattern print date
O4 <YY><MM><DD>
Job information print times
O5 <nnnnnnnnn>
Final job information print date
O6 <YY><MM><DD>
User paper No. change times
O7 <nnnnnnnnn>
Cut pressure change times
O8 <nnnnnnnnn>
Cut method change times
O9 <nnnnnnnnn>
Thank You For Using TheServiceManualShop.com
Thank You For Using TheServiceManualShop.com