-271
4. Carefully pull down the jammed paper. TURN PWR OFF AND
ON is displayed on the LCD panel.
5. Close the front cover, if necessary, then press the Power
button to turn the printer off and back on.
6. Make sure that the Paper Out light is on and LOAD PAPER is
displayed on the LCD panel. To load paper see “Using Roll
Paper” or “Using Cut Sheet Media”.
Note:
When you install two roll paper spindles, secure the roll paper that you
are not using with the roll paper belt packed with your printer. See
“Using the roll paper belt”.
If you do not resume printing afterwards, make sure the print
heads are in the home (far right) position. If not, turn the printer
on, wait until the print heads move to the home position, then
turn off the printer.
c
Caution:
If the print heads are not left in the home position, print quality
may decline.
To Next Page
Loading...
