-91
Note:
The default value depends on the PAPER THICK. value in the Head
Alignment menu and is displayed as a PAPER THK NO. in the Paper
Configuration menu as shown below:
8. Press the Enter button to save the selected value.
9. Press the Item button to display CUT PRESSURE. Press + or -
button to set the cutter pressure for cutting paper, then the
Enter button.
10. Press the Item button to display CUT METHOD. Press + or -
button to select either 3 STEP or 4 STEP, then the Enter button.
Note:
When cutting non-EPSON media and weaker or thick paper, 4
STEP is recommended.
11. Press the Item button to display PPR FEED ADJ. Press the + or
- button to set the paper feed amount, then the Enter button.
12. Press the Item button to display PRINT ADJUSTMENT. Press +
or - button to adjust MicroWeave, then the Enter button. The
setting range is 1 to 9. Increase the value to give priority to
printing speed. Decrease it to give priority to the print quality.
13. Press the Item button. DRYING TIME appears. Press the + or -
button to select time in minutes.
14. Press the Enter button to save the selected value.
15. Press the Item button to display SUCTION. Press + or - button
to select NORMAL, WEAK or WEAKEST.
PAPER THICK. value PAPER THICK. NO.
0.0 MM to 1.6 MM AUTO, 1 to 17
To Next Page
Loading...
