Epson Stylus Pro 3800 - Page 143

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 143
REASSEMBLY
1.
Slide the FRAME, PAPER, EJECT, ASSY back and forth until the guide holes of the
LINK, EJ, LEFT/RIGHT and GUIDE, PAPER GUIDE, BOARD PAPER, LEFT/
RIGHT come in the positions shown in the Figure 4-66 and Figure 4-67.
2. Put the pivot of the left of the BOARD PAPER TRAY into the guide holes of the
LINK, EJ, LEFT and GUIDE, PAPER GUIDE, BOARD PAPER, LEFT shown in
the Figure 4-66.
3. Slide the right pivot of the BOARD PAPER TRAY along the guide groove of the
GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT shown in the
Figure 4-65 , and
put the pivot into the guide holes of the LINK, EJ, RIGHT and GUIDE, PAPER
GUIDE, BOARD PAPER, RIGHT shown in the Figure 4-67.
4. After the above steps, follow step 1. to step 11. of the disassembly procedure in
reverse order to reassemble the BOARD PAPER TRAY.
Figure 4-65. Inserting the Right Pivot
Figure 4-66. Guide holes of the LINK, EJ, LEFT and GUIDE, PAPER GUIDE,
BOARD PAPER, LEFT
Figure 4-67. Guide holes of the LINK, EJ, RIGHT and GUIDE, PAPER GUIDE,
BOARD PAPER, RIGHT
GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT
FRAME, PAPER,
EJECT, ASSY
guide groove
GUIDE, PAPER GUIDE, BOARD PAPER, LEFT
LINK, EJ, LEFT
Left side
BOARD PAPER
TRAY
guide hole
Right side
GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT
guide hole
guide groove
BOARD PAPER
TRAY
LINK, EJ, RIGHT