Epson Stylus Pro 3800 - Page 145

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 145
6. Release the rear end of the TORSION SPRING, 0.15 from the cutout of the main
frame in the direction of the arrow, and remove the TORSION SPRING, 0.15 from
the GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT.
7. Remove the two screws that secure the GUIDE, PAPER GUIDE, BOARD
PAPER, RIGHT.
 Two C.B.P. 3 x 6 screws (9 ± 1 kgf.cm)
Figure 4-69. Removing the TORSION SPRING, 0.15 and the screw from the GUIDE,
PAPER GUIDE, BOARD PAPER, RIGHT
C H E C K
P O I N T
When removing/installing the C.B.P. 3x6 screws that secure the
GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT, use a stubby
screw driver or put a screwdriver (with a 110 mm or longer shaft is
recommended) through the holes on the FRAME, ASSY., SUB,
RIGHT as shown in Figure 4-69.
C.B.P. 3x6
TORSION SPRING, 0.15
GUIDE, PAPER GUIDE, BOARD PAPER, RIGHT
Put the screwdriver
through this hole.