Epson Stylus Pro 3800 - Page 169

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 169
4.3.9.8 CABLE ASSY., ASP
DISASSEMBLY
1. Remove the HOUSING, UPPER. (p107)
2. Remove the COVER, CR. (p152)
3. Remove the INK, SYSTEM, ASSY. (p153)
4. Remove the PRINT HEAD. (p161)
5. Carry out step 1. to step 11. of “4.3.3.15 BASE, ENCLOSURE” (p111) to pull out
the BASE, ENCLOSURE.
6. Disconnect the cables from CN63, CN69, CN70, CN71 and CN72 on the BOARD
ASSY., MAIN.
7. Remove the two screws that secure the HOLDER,FFC,TUBE.
 Two C.B.P. 3 x 8 screws (6 ± 1 kgf.cm)
8. Slide the HOLDER,FFC,TUBE in the direction of the arrow to release the two
hooks, and remove the HOLDER,FFC,TUBE.
Figure 4-100. Disconnecting the Cables
Figure 4-101. Removing the HOLDER,FFC,TUBE
C A U T I O N
When reassembling the CABLE ASSY., ASP, make sure to follow
the procedure described from
p171. Otherwise, the product quality
may not be maintained.
CN69
CN70
CN71
CN72
CN63
HOLDER,FFC,TUBE
C.B.P. 3x8
Hooks