Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 171
REASSEMBLY
Preparing the tool
When reassembling CABLE ASSY., ASP, use a “Space Making Jig” to keep
the proper clearance between the ink tube and CABLE ASSY., ASP. Follow
the steps below to create the tool using three pieces of the Holder, FFC.
1. Cut each of the three Holder, FFC on a dotted red line shown in the figure. The
portion shown in the blue box is used.
2. Wrap 3 portion of the Holder, FFC together with a cellophane tape and fix it. This
unit is used as a “Space Making Jig”.
Figure 4-104. Preparing the Space Making Jig
Holder, FFC
Space Making Jig
Cutoff line
To Next Page
Loading...
