Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 172
Procedure
1. Connect the FFCs (CN1, CN2) to the PRINT HEAD.
2. Install the PRINT HEAD to the CARRIAGE, ASSY.
3. Slide the GUIDE, TUBE, CR in the direction of the arrow to insert the two holes
of the GUIDE, TUBE, CR over the tabs of the CARRIAGE, ASSY. Make sure
that the positioning tab of the CARRIAGE, ASSY sticks out from the positioning
hole of the GUIDE, TUBE, CR.
Figure 4-105. Installing the PRINT HEAD
Figure 4-106. Installing the GUIDE, TUBE, CR
PRINT HEAD
CN1
CN2
HARNESS, HEAD, A/B
Positioning tab and hole
GUIDE, TUBE, CR
Tabs and holes
To Next Page
Loading...
