Epson Stylus Pro 3800 - Page 201

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 2) 201
4.4.1.2 PULLEY, DRIVEN, ASSY.
1. Remove the HOUSING, UPPER. (p107)
2. Remove the ASF, ASSY. (p197)
3. Remove the EXTENSION SPRING 28.38 from the each hook of the main frame
and the HOLDER, PULLEY, DRIVEN.
4. Slide the HOLDER, PULLEY, DRIVEN to the right to disengage the two tabs,
and remove the HOLDER, PULLEY, DRIVEN to the front.
5. Push down the PULLEY, DRIVEN, ASSY., to release the PULLEY, DRIVEN,
ASSY. and the BELT, CR from the HOLDER, PULLEY, DRIVEN.
Figure 4-152. Removing the EXTENSION SPRING 28.38 and HOLDER, PULLEY, DRIVEN
Figure 4-153. Removing the PULLEY, DRIVEN, ASSY.
Be sure to install the PULLEY, DRIVEN, ASSY. to the HOLDER,
PULLEY, DRIVEN so that the protrusion on the shaft of the
PULLEY, DRIVEN, ASSY. faces downward.
Rear side
HOLDER, PULLEY, DRIVEN
EXTENSION SPRING 28.38
tabs
protrusion
Left front side
HOLDER, PULLEY, DRIVEN
PULLEY, DRIVEN, ASSY.
BELT, CR