Epson Stylus Pro 3800 - Page 158

Problem Solver 158
EPSON Stylus Pro 3800 User’s Guide
❏ For Windows, check the Media Type setting in the Main menu. Make sure it is correct
for the paper you are using. See “Making Settings on the Main Menu” on page 14.
For Mac OS X, check the Media Type setting in the Print Settings selected in the Print
dialog. Make sure it is correct for the paper you are using. See “Page Setup” on page
75.
❏ Run the Head Cleaning utility to clear any clogged ink nozzles. For Windows, see
“Cleaning the print head” on page 48. For Mac OS X, see “Cleaning the print head” on
page 92.
You can also clean the print head nozzles using the control panel. To clean the print
head nozzles, press the Menu/Right r button for 3 seconds.
❏ Check the ink status light. If necessary, replace ink cartridges. See “Replacing Ink
Cartridges” on page 133.
❏ Select Standard as Platen Gap in the Paper Configuration dialog box. For Windows,
see “Paper Configuration” on page 20. For Mac OS X, see “Paper Configuration” on
page 83.
Blurry or smeared printout
Try one or more of these solutions:
❏ For Windows, check the Media Type setting in the Main menu. Make sure it is correct
for the paper you are using. See “Making Settings on the Main Menu” on page 14.
For Mac OS X, check the Media Type setting in the Print Settings selected in the Print
dialog. Make sure it is correct for the paper you are using. See “Page Setup” on page
75.
❏ If the paper you are using is not supported by the printer driver, make the paper
thickness setting in Menu mode. See “CUSTOM PAPER” on page 104.
❏ Make sure your paper is dry and the printable side is face-up. Also, make sure you are
using the correct type of paper. See “Paper” on page 186.
❏ Ink may have leaked inside the printer; wipe the inside of the printer with a soft, clean
cloth.
❏ Run the Head Cleaning utility. For Windows, see “Cleaning the print head” on page 48.
For Mac OS X, see “Cleaning the print head” on page 92.
You can also clean the print head nozzles using the control panel. To clean the print
head nozzles, press the Menu/Right r button for 3 seconds.