Epson Stylus Pro 3850 - Printer Mechanism

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 1) 196
4.3.12 PRINTER MECHANISM
4.3.12.1 Replacing the PRINTER MECHANISM
 Name: PRINTER MECHANISM, ASP
1. Remove the parts listed below from the old printer, and install them to the
PRINTER MECHANISM, ASP except for the consumables.
 Consumable goods (Ink cartridge, Maintenance cartridge)
 BOARD ASSY., MAIN
 PAPER, SUPPORT, MANUAL, ASSY.
 PAPER, SUPPORT, ASSY.
 STACKER, C
2. A CD-ROM that contains mechanism parameter data comes with the PRINTER
MECHANISM, ASP. Load the CD-ROM into to the PC.
3. Start up the Adjustment program.
“NVRAM Backup utility” will automatically start up when the Adjustment
program is started. Using the utility, write the mechanism parameter data into the
PRINTER MECHANISM, ASP. See Chapter 5 “5.3.6 Parameter Backup” (Page
231) for the operation instructions.
C H E C K
P O I N T
When the PRINTER MECHANISM, ASP needs to be replaced due
to a failure of the BOARD ASSY., MAIN, the BOARD ASSY.,
MAIN also must be replaced with a new one.