Epson Stylus Pro 3850 - 4.4 Disassembly;Assembly Procedure (Group 2)

Epson Stylus Pro 3800/3800C/3850/3880/3885/3890 Revision C
DISASSEMBLY & ASSEMBLY Disassembly/Assembly Procedure (Group 2) 197
4.4 Disassembly/Assembly Procedure (Group 2)
This section describes disassembly/assembly procedures required only for off-site
servicing.
4.4.1 Removing the PAPER FEED MECHANISM
4.4.1.1 ASF, ASSY.
1. Remove the HOUSING, UPPER. (p107)
2. Carry out step 1. to step 9. of “4.3.3.15 BASE, ENCLOSURE” (p111), and remove
the PAPER, GUIDE, LOWER, L and PAPER, GUIDE, LOWER, R.
3. Remove the two screws that secure the left and right GUIDE, ROLLER, LDs, and
remove the two GUIDE, ROLLER, LDs. See Figure 4-147.
 Two (one for each) C.B.S. 3 x 6 screws (9 ± 1 kgf.cm)
4. Lift up the two GUIDE, ROLLER, LDs on the rear side of the main unit to
disengage the hook and the tab, and remove the GUIDE, ROLLER, LDs.
See
Figure 4-148.
Figure 4-147. Screws, hooks and tabs that secure the GUIDE, ROLLER, LD
Figure 4-148. Removing the GUIDE, ROLLER, LDs
C H E C K
P O I N T
When removing/installing the screw that secures the GUIDE,
ROLLER, LD on the left side, use a screwdriver with a 100 mm or
shorter shaft.
hook
tab
Front side of the printer
C.B.S. 3x6
Rear side of the printer
GUIDE, ROLLER, LDs