Stylus Pro 4000 Field Repair Guide 4/28/05
Auto Uni-D Adjustment Printer Component, Software Item, LCD Display, Printer Button Page 139.
Auto Uni-D Adjustment
1. Load 17” Enhanced Matte roll paper.
2. From the Adjustment Wizard for the Pro 4000, select the Auto Uni-D Adjustment.
1. Click on the Run button.
2. The Printer will print out these patterns. It will
take approximately 15 minutes
4. Click the Finish button.
3. The Printer will read the alignment patterns
automatically (using the Multi Sensor), and
write the appropriate values to the board.
To Next Page
Loading...
