Stylus Pro 4000 Field Repair Guide 4/28/05
T&B&S [Cut Sheet] Adjustment Printer Component, Software Item, LCD Display, Printer Button Page 188.
T&B&S [Cut Sheet] Adjustment
1. Load A4 Enhanced Matte cut sheet paper.
2. From the Adjustment Wizard for the Pro 4000, select the T&B&S [Cut Sheet].
1. Click on the Print button.
2. The Printer will print out this pattern, and mea-
sure the side margin using the Multi Sensor.
3. Measure the top (leading edge) margin, and
enter the value measured.
10. Click the Finish button.
4. Measure the bottom (trailing edge) margin, and
enter the value measured.
5. Enter the side margin value printed on the print
out, labeled “Side Margin Adjust”.
7. Repeat Steps 1 - 4.
8. Measure the side margin, and enter the value.
6. Click the Write button.
9. Click the Write button.
To Next Page
Loading...
