Epson Stylus Pro 4000 - Page 13

The Control Panel 13
1
1
1
1
1
1
1
1
1
1
1
1
3Paper Source
button
Selects the paper source (Roll Auto Cut On
/Roll Auto Cut Off /Sheet )
Cuts the roll paper automatically after printing
if pressed and held for 3 seconds when Roll
Auto Cut On is selected.
Returns to the previous level when pressed in
SelecType mode.
4 Paper Feed
button
Feeds paper in forward.
Ejects the cut sheet when Sheet is selected
as the paper source.
Feeds roll paper before cutting it when Roll
Auto Cut On setting is selected as the
paper source.
Loads a sheet from the paper tray to the
printing position automatically if Sheet is
selected as the paper source.
Selects a desired parameter from the selected
item if pressed in SelecType mode.
Changes the parameters in forward order
when selecting a desired parameter in
SelecType mode.
5 Paper Feed
button
Feeds paper in reverse as much as the paper
has been fed by using the Paper Feed button
.
Note:
If you have feed the paper forward by hand,
you cannot feed the paper in reverse by using
this button.
Loads a sheet from the paper tray to the
printing position automatically if Sheet is
selected as the paper source.
Selects a desired parameter from the selected
item if pressed in SelecType mode.
Changes the parameter in reverse order when
selecting a desired parameter in SelecType
mode.