19
Installing and Setting Up the Server Software | 19
•
Choose Roll fed media or Sheet fed media, depending on the
paper source you are using
• Choose Borderless printing to allow edge-to-edge printing
• Choose Bidirectional Printing to print in both directions (turn
this off for best quality)
• Choose Cut media to allow the printer to use the printer’s cut
method to cut roll paper
• Enter a value in the Micro media feed adjustment box if you
need to adjust the setting for precise paper feeding
7. Click
OK.
8. From the Environment menu, click
Load.
9. Open the
Color or Grayscale folder, then choose the environment file
for your paper type and resolution.
10. Click
Open, then click Yes.
11. Click
Start Spooler to start the RIP.
ColorBurst.book Page 19 Thursday, September 9, 2004 12:41 PM
To Next Page
Loading...
