Epson Stylus Pro 4400 - Page 160

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Troubleshooting Troubleshooting Based on Panel Messages 160
.
Note *1: Blink correspond ink indicator.
*2: Paper check LED flashes at 5-second intervals.
*3: Occurs only when the remaining paper detection is on with roll paper or cut paper loaded.
*4: Display by switching at 3-second intervals.
*5: To promote that release is available by [Pause] key, display the following display by turns at 1 sec., intervals.
"PRESS PAUSE BUTTON"
*6: Received data is initialized without initializing mechanisms (including completion of forced cleaning) even if panel reset has been done.
*7: Displalys the request below when the rear sensor detects no paper after the paper is removed.
“TURN PRINTER PWR OFF AND THEN ON”
REAR COVER OPEN Rear Cover open – – – p.173
OPTION I/ F ERROR Type-B Option I/ F Card Error Blink Blink Blink p.173
UNLOCK
PRINT HEAD
CR lock unlocked error
Blink Blink Blink p.173
High
SERVICE REQ.
nnnnnnnnn
Service request, CR servo error (fatal error)
Blink Blink Blink Refer to Table3-2
Table 3-1. Displayed Error Messages
Priority LCD Panel Message Displayed Error
LED
Reference Page
Paper Check Pause Ink Check