Epson Stylus Pro 4400 - Page 170

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Troubleshooting Troubleshooting Based on Panel Messages 170
WRONG LOGO ERROR
INK CARTRIDGE FAILURE
NO INK CARTRIDGE
MAINTENANCE TANK FULL
RELEASING LEFT AND RIGHT (LEFT OR RIGHT) INK LEVER
LCD Explanation Recovery
INVALID INK CRTG This error occurs when an ink cartridge other than genuine one is
inserted.
Replace the ink cartridge with a genuine one.
Recover from the error forcibly by pressing the [Pause] key.
LCD Explanation Recovery
SET INK CRTG Ink Cartridge problem or failure of reading/writing to CSIC. It is cleared by inserting proper Ink Cartridge, which the panel
displays, and pulling down the Ink Lever.
Check CSIC contact terminals of Ink Cartridge Holder for damage,
deformity. If CSIC contact terminals are not normal, replace I/H Left
Unit (or I/H Right Unit).
LCD Explanation Recovery
NO INK CRTG There is no Ink Cartridge installed. Open I/H Cover and properly install the Ink Cartridge indicated by the
LCD panel. Or insert a new Ink Cartridge and pull down the Ink Lever
to clear the error.
There detected any Ink Cartridge slot without cartridge.
LCD Explanation Recovery
MNT TNK FULL This error occurs when Maintenance Tank is full. Install usable Maintenance Tank.
LCD Explanation Recovery
LOWER INK LEVERS The Ink Lever is raised (released) during one of the movements. Pull down the Ink Lever.
LOWER L INK LVR
LOWER R INK LVR