EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Troubleshooting Troubleshooting Based on Panel Messages 172
RELEASING PAPER LEVER IN OPERATION
PAPER JAM(ASF)
PAPER JAM(CR)
LCD Explanation Recovery
SET PAPER LEVER Paper Lever was released during one of the movements. Pull down the Paper Lever.
After lowering the lever, the paper set sequence will begin, and the
paper type will be automatically determined by paper detection
sensors (PE Sensor, Rear Manual Insertion Sensor, ASF Paper
Sensor). In this case, the paper initialization start trigger wait period
will execute continuously, so the paper set sequence is resumed by
pressing the [Pause] key. (However, when the Paper Lever has
been lowered after removing paper without cancelling the job
(pressing the [Pause] key) while the Paper Lever was raised,
"Paper end/roll paper end (p.166)" occurs after clearing this error.
When only the PE Sensor turns ON with the Paper Lever lowered,
front paper supply is determined by the paper set sequence, and
because a paper jam can be caused by back feeding, a message is
displayed on the printer about removing paper and operation is
stopped. In this case, release the Paper Lever again and remove
the paper, and then lower the lever to clear the error.
When only the PE Sensor turns ON at paper feed/print/eject
movements of ASF or rear manual insertion, "Paper eject error
(p.166)" occurs after clearing this error.
LCD Explanation Recovery
RELEASE LEVER
REMOVE PAPER JAM
The ASF Paper Sensor is ON at ASF paper feed movement but the
PE Sensor does not turn ON. Or the ASF Paper Sensor and PE
Sensor are both ON, but the paper top edge cannot be detected.
Release Paper Lever, remove paper, and pull down the lever.
However, if this was generated during printing, when the paper is
removed by the above method and the Paper Lever is lowered, "Paper
end/roll paper end (p.166)" occurs after clearing this error.
When only the PE Sensor turns ON at paper feed/eject movements of
ASF, "Paper eject error (p.166)" occurs after clearing this error.
The Rear Manual Insertion Sensor turned ON at paper feed
movement by ASF.
ASF Paper Sensor or PE Sensor does not turn OFF at paper eject
movement after printing by ASF feed.
LCD Explanation Recovery
RELEASE LEVER
REMOVE PAPER JAM
This error occurs when CR Motor step-out is detected due to paper
jam while CR Motor is operating.
Release the Paper Lever to remove the paper, pull down the lever,
and then turn the printer off and back on.
To Next Page
Loading...
