Epson Stylus Pro 4400 - Motor Assy., PF; Releasing Guide, FFC

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 349
4.2.9.3 Motor Assy., PF
1. Remove "Cover, Side, Left" (p216).
2. Disconnect "Motor Assy., PF" harness (CN14: black, 2 pin) from "C593
MAIN Board" and peel off the acetate tape to release the harnesses.
(Refer to "4.2.4.1 C593 MAIN Board" (p226).)
3. Release "Motor Assy., PF" harness and other harnesses from the two tabs
and the three grooves on "Paper Guide, Lower". (Refer to Figure 4-207.)
4. Peel off the pieces of acetate tape to release "Motor Assy., PF" harness
and then pull it through the hole in the frame. (Refer to Figure 4-208.)
5. Remove the two screws securing the "Guide, FFC" and then lower the
"Guide, FFC" along with all FFCs.
(Refer to Figure 4-209.)
 C.B.S. 3x6: 1 pc.
 C.B. 3x4: 1 pcs.
Figure 4-207. Releasing the Harness_1
Figure 4-208. Releasing the Harness_2
Figure 4-209. Releasing Guide, FFC
Align the dowel of the frame with "Guide, FFC" positioning
hole. (Refer to Figure 4-209.)
Harness Tabs Paper Guide, Lower
Channels
Acetate Tape (x3)
Motor Assy., PF
Guide, FFC FFC
C.B. 3x4
Dowels and Positioning Holes
C.B.S 3x6