Epson Stylus Pro 4450 - Carriage, C Removal; Separation from Carriage, B

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 289
11. Slowly draw the "Carriage, C" to the directions shown in Figure 4-111 to
separate it from the "Carriage, B". (Refer to Figure 4-112.)
Figure 4-111. "Carriage, C" Removal
Figure 4-112. Separation from Carriage, B
C A U T I O N
When performing the following work, do not keep the
"Carriage, C" too far because harnesses are connected to
the "Carriage, C".
Make sure that the mounting plate of the "Carriage Unit" is in
contact with the one of the "Carriage, C" after installing the
"Carriage, C".
Carriage, C
Carriage, B
Carriage, C
Printhead
Headrank ID Label