Epson Stylus Pro 4450 - Page 310

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 310
11. Remove the four clamps securing the harnesses. (The "Sheet Ink Stopper"
will be released at the same time.)
12. Release both the FFC and the harnesses from the tabs of the printer.
(Refer to Figure 4-145.)
Figure 4-144. Releasing Harnesses_3
Figure 4-145. Releasing Harnesses_4
"Sheet Ink Stopper, D" should be attached to the printer
frame with the three tabs of the clamps inside the printer as
shown in Figure 4-144.
Secured together with Sheet
Ink Stopper, D
Sheet Ink Stopper, D
Clamps
Tabs