Epson Stylus Pro 4900 - Page 123

A
Remove the output tray.
Lift the edge of the output tray slightly to remove
it. Also remove the optional SpectroProofer if
installed.
B
Release the Maintenance Box 2 lock.
C
Pull Maintenance Box 2 out carefully so that it
does not tilt.
c
Caution:
If ink should spill out onto your skin or into
your eyes, wash the affected area with water
immediately.
D
Place the used Maintenance Box 2 in the clear bag
included with your new Maintenance Box 2, and
make sure that the zipper is closed tight.
Note:
Do not tilt Maintenance Box 2 until it is completely
in the clear bag and the zipper is closed. The waste
ink may leak and soil the surrounding area.
E
Insert the new Maintenance Box 2.
Push it in firmly.
Note:
Do not touch the green IC chip on the side of
Maintenance Box 2. Doing so may prevent normal
operation and printing.
Epson Stylus Pro 4900/4910 User's Guide
Maintenance
123