Epson Stylus Pro 4900 - Page 133

Error messages What to do
Paper Jam
Remove paper from printer.
Power off and then on.
Refer to the "Roll paper jam", "Cut sheets from the paper cassette have jammed while
printing", or "Cut sheets from the front/rear manual feeder have jammed" sections on the
reference page that follows and remove the jammed paper.
U “Feeding or ejecting problems” on page 146
Paper Load Error
Press the u button and remove the
jammed paper.
Refer to the "Cut sheets from the front/rear manual feeder have jammed" section in the
chart on the following reference page and remove the jammed paper.
U “Feeding or ejecting problems” on page 146
Paper Load Error
Press the Y button and remove the
jammed paper.
Refer to the "Cut sheets from the front/rear manual feeder have jammed" section in the
chart on the following reference page and remove the jammed paper.
U “Feeding or ejecting problems” on page 146
Paper Load Error
Press the Y button and reset roll
paper.
Press the Y button to rewind the roll paper, then load it into the printer.
U “Loading roll paper” on page 29
Paper Load Error
Remove paper cassette to fix paper
jam.
Refer to the "Cut sheets from the paper cassette have jammed while printing" section in
the chart on the following reference page and remove the jammed paper.
U “Feeding or ejecting problems” on page 146
Paper Load Error
Remove paper from rear manual
feeder and press the d button.
Refer to the "Cut sheets from the front/rear manual feeder have jammed" section in the
chart on the following reference page and remove the jammed paper.
U “Feeding or ejecting problems” on page 146
Paper Load Error
Remove the rear unit to fix paper
jam.
Refer to the "Cut sheets from the paper cassette have jammed while printing" section in
the chart on the following reference page and remove the jammed paper.
U “Feeding or ejecting problems” on page 146
Paper Low Prepare a new roll paper for replacement.
U “Loading and Removing the Roll Paper” on page 26
Paper Out
For paper less than 0.8 mm
thickness, insert from rear manual
feeder.
For thicker paper, press Y button
then insert from front manual
feeder.
Load the paper into the rear manual feeder or front manual feeder depending on the
thickness of the paper.
U “Loading Manually from the Rear” on page 39
U “Loading and Ejecting Thick Paper” on page 40
Paper Out
Load paper in paper cassette.
Confirm that no paper is being printed, then remove the paper cassette and load the
paper.
U “Loading the Paper Cassette” on page 35
Paper Out
Press the Y button.
Press the Y
button then load the roll paper.
U “Loading Roll Paper” on page 27
If you run out of paper while printing, the remaining data is printed once you load new
paper. If you want to print from the beginning on the new paper instead of continuing
from where the job was paused, press the W button and select Job Cancel. After that,
load the new paper and perform the print operation again.
Epson Stylus Pro 4900/4910 User's Guide
Problem Solver
133