Error messages What to do
Paper Source Error
Roll paper is loaded.
Remove it and change paper source
to cut sheet.
Press the Z button to clear the message, and then remove the roll paper from the printer
and change the source in the Paper Type menu. When Auto Roll Feeding is set to Off from
the Menu, you cannot change the paper type when roll paper is fed.
U “Removing the roll paper” on page 32
Printer Cover Open
Please close the cover.
Close the printer cover.
Replace Maint Box 1
At the end of service life. Replace
maint box 1.
Replace Maintenance Box 1 with a new one.
The on-screen message reads Maintenance Box 1, however the product name for this
consumable is Maintenance Box.
U “Replacing Maintenance Box 1” on page 121
Replace Maint Box 2
To continue borderless printing,
replace maint box 2.
To perform borderless printing you must replace Maintenance Box 2.
The on-screen message reads Maintenance Box 2, however the product name for this
consumable is Borderless Maintenance Box.
U “Replacing Maintenance Box 2” on page 122
SpectroProofer Error
Connect cable of SpectroProofer
then restart printer.
Turn off the printer and connect the SpectroProofer mounter's printer connector cable.
Turn on the printer once you are sure the printer connector cable is connected properly.
U SpectroProofer Mounter 17" Setup Guide (Sheet)
SpectroProofer Error
Refer to the manual and connect
the ILS20EP to SpectroProofer.
Turn the printer power off, and then
on again.
Turn off the printer, and then remove the color measurement device from the
SpectroProofer mounter. Reinstall it correctly and then turn on the printer.
U SpectroProofer Mounter 17" Setup Guide (Sheet)
Epson Stylus Pro 4900/4910 User's Guide
Problem Solver
135
To Next Page
Loading...
