Epson Stylus Pro 4900/Epson Stylus Pro 4910 Revision A
ADJUSTMENT Ink Supply Related Checks and Adjustments 358
Confidential
4.12.3 Ink Eject and Initial Charge
4.12.3.1 Ink Eject
EXECUTION MODE
Serviceman Mode
PROCEDURE
1. Turn the printer ON in the Serviceman Mode.
Turn the power ON while pressing [Menu ] + [Paper Feed ] + [OK].
2. Start the Service Program and select Ink Eject and Initial Charge.
3. Select Ink Eject and select the ink holder from which ink is ejected.
4. Click [Run].
5. Follow the instructions on the screen to remove all ink cartridges of the selected
ink holders.
Ink is ejected.
Figure 4-71. [Ink Eject] Screen
C H E C K
P O I N T
Required time per Ink Eject (all rows): 7 minutes
C A U T I O N
If ink is ejected just one time, ink may leak when removing the ink
tube. Therefore, it is better to prepare paper or cloth to clean away
the ink beforehand or eject ink twice in a row.
To Next Page
Loading...
