6
Unpacking the printer
c
Caution:
The printer unit is heavy and unwieldy. Have
two people unpack the printer unit, and four
people place the printer unit on top of the base
unit.
1. Remove the roll paper spindle with roll paper,
polystyrene foam, and cardboard cushions
from around the printer.
2. Lift the box up and away from the printer.
Remove all items from the hollow (A and B)
on the rear side of the printer.
Note:
The ink cartridges included with your printer are
primarily for initial setup.
3. Take out the cardboard panels from the
printer.
Mounting the printer on the base unit
1. Lock the two front casters (J).
Note:
Place the casters sideways and lock them so they
will not move.
2. Position the base unit in front of the printer
unit as shown.
3. Mount the printer on the base unit as shown
below.
c
Caution:
Do not attempt to lift the printer unit with
fewer than four people.
J
To Next Page
Loading...
