The Control Panel 193
3. Press the Paper Feed d button or Paper Feed u button to
display ROLL PAPER COUNTER, and then press the Menu r
button.
4. Press the Paper Feed d button or Paper Feed u button to
select the length of the roll paper (between 5 and 99.5 m or 15
and 300 ft), and then press the Enter button.
5. The screen changes so that you can select the alert value. Press
the Paper Feed d button or Paper Feed u button to select
the alert value (between 1 and 15 m or 3 and 50 ft).
6. Press the Enter
button to set the alert value.
7. After you set the alert value, press the Pause
button to
return to the READY state.
Maintenance Mode
Maintenance mode setting procedure
This section describes how to enter Maintenance mode and make
settings with the buttons on the control panel.
To make Maintenance mode settings, follow the steps below.
Note:
❏ Press the Paper Source l button to return to the previous step.
❏ While you are using the printer in Maintenance mode, no error
message (if any) appears on the LCD panel. Therefore, use
Maintenance mode when the printer is in the normal state (no error).
To Next Page
Loading...
