Paper Handling 206
Loading roll paper
To load roll paper, follow the steps below.
Note:
You may want to setup the paper basket before printing. See “Setting
the Paper Basket” on page 237.
1. Open the roll paper cover. Make sure that the roll paper is
attached to the printer properly.
2. Make sure that the printer is on.
3. Make sure that the Power light is not flashing, and then set
the paper lever to the released position. The LEVER RELEASED.
LOAD PAPER appears on the LCD panel.
c
Caution:
Do not set the paper lever to the released position while the
Power light is flashing. Doing so may damage the printer.
To Next Page
Loading...
