Epson Stylus Pro 7500 - Page 119

EPSON Stylus Pro 7500 Revision A
Disassembly & Assembly Disassembly Flow 119
6. Take out the damper assembly connected to each print head (there are 3 for one print
head).
As shown in the figure below, inset a flat blade screwdriver, etc. between the carriage
and the projection on the damper’s left side and pry with it using the lever principle to
make it easy to remove.
NOTE1:If you press on the transparent film on the damper’s right side surface
with your fingers, the ink with which the inside is filled will be expelled,
so do not press on this part.
NOTE2:The transparent film on the damper’s side is delicate, so be careful not to
damage it while working.
Figure 4-38. Damper Removal
7. Using round-nosed pliers, remove the “Tension Spring, 9.9” from the C head on the
right.
8. Remove one screw (CB M3x6), also called the “H Spacer” screw, and then remove the
printhead from the carriage.
9. Remove the flat cable from the back of the printhead.
NOTE: Care should be taken not to touch the nozzle surface of the print head that
you are installing or allow dirt, etc. to adhere to it.
Figure 4-39. Printhead Tension Spring and Screw Removal 1/2
damper ASSY
(for head right side)
damper ASSY
(for head left side)
(-)driver
print head (right)
screw (CB M3x6)
H Spacer
tension spring
.9.9