Epson Stylus Pro 7500 - Page 16

EPSON Stylus Pro 7500 Revision A
Product Description Print Specifications 16
¡: Compatible Paper, –: Nonexistent Type of Paper
*1: Guaranteed for Uni-D printing.
*2: Paper that exists oversees only.
*3: The paper should be loaded longitudinally.
*4: There should be no wrinkles, fuzz or tearing of the paper, etc.
*5: This product should be used in a place with a normal room temperature environment
(Temperature: 15~25°C, Relative humidity: 40~60%).
• The printer detects the paper width when the paper is set.
• Any image that exceeds the detected paper width, or the printable area specified by
the paper size setting, is not printed.
• The size of the margin of roll paper can be changed from the panel as shown below.
Top and Bottom: 15 mm Left and Right: 3 mm / Top, Bottom, Left and Right: 3 mm
/ Top, Bottom, Left and Right: 15 mm.
[EPSON Special Papers]
Shown below.
Table 1-7. Specifications of EPSON Special Papers
Size Name
Dimensions
(H x W)
Super Fine
*1
Photo Print
Paper 2
Photo
Quality
Glossy Film
Art Board
A4 210 x 297mm ¡¡¡–
A3 297 x 420mm ¡ ¡ ¡
*2
–
Super A3 329 x 483mm ¡¡¡–
A2 420 x 594mm ¡ – – –
LTR 216 x 279mm ¡¡¡–
B 279 x 432mm ¡
*2
¡
*2
¡
*2
–
C 431 x 558mm ¡
*2
–––
B2 515 x 728mm – – – ¡
Printable Area: See the table and figure below.
Table 1-8. Printable Area
Heading Roll Paper Cut Sheets
PW (width)
210 ~ 610mm
(8.27 ~ 24”)
210 ~ 610mm
(8.27 ~ 24”)
PL (length)
Max. 90m
(298.8’)
297~915mm
(11.8~36.4”)
LM (left margin)
3mm/15mm*
(0.12~0.59”)
3mm
TM (top) 3mm/15mm* 3mm
RM (right) 3mm/15mm* 3mm
BM (bottom) 3mm/15mm* 14mm