EPSON Stylus Pro 7600/9600 Revision A
Troubleshooting Troubleshooting Based on Your Printout 150
3.3.6 Banding in the paper feed direction
If banding (uneven density, rough image) in parallel with the paper feed direction is
found on the print, perform the following adjustment:
Bi-D adjustment:
The Bi-D adjustment can be executed by any of the following methods.
“Gap Adjustment” in the panel setting menu
Adjustment by printer driver
If the adjustment above does not work to improve the print quality, you may improve it
by adjusting the “Paper thickness” setting value (± 0.1 ~ 0.2 mm) in “User Paper
Setting Menu” of the panel setting menu.
To Next Page
Loading...
