EPSON Stylus Pro 7600/9600 Revision A
Disassembly & Assembly Removing the Panel Unit and Housing 160
4.2.2 R Side Cover
1.
Remove the Panel Unit. (p.159)
2. Push back the Paper Set Lever to the released position.
(See Figure 4-6)
3. Remove two black screws (CBP: M4
×
10) from the lever handle, and remove the
handle.
4. Using a (-) driver or similar tool, remove the lever blind cap.
5. Open the roll paper cover.
(See Figure 4-7)
6. Remove the one black screw (CBP: M4
×
10) from inside the printer.
Figure 4-6. R Side Cover Removal 1/5
Figure 4-7. R Side Cover Removal 2/5
C H E C K
P O I N T
Take care not to drop the lever blind cap into the printer.
Adjust the height of the Paper Set Lever by means of the black
screws so that the Paper Set Lever does not come in contact with the
Lever Blind Cap.
Paper Set Lever
Lever Blind Cap
Black screws (CBP: M4×10) ×2
Black screws (CBP: M4×10)
Roll Paper Cover
To Next Page
Loading...
