Epson Stylus Pro 7600 - EPSON Stylus Pro

EPSON Stylus Pro 7600/9600 Revision A
Disassembly & Assembly Disassembly and Assembly of Carriage (CR) Mechanism 172
4. Loosen the left screw for the Head Holder , remove the right screw (M3 × 6) and release
the Head Holder downward.
(See Figure 4-26)
5. Take out the head by lifting its inner side and release the 2 FFCs. (See Figure 4-27)
Figure 4-26. Head Holder Release
Figure 4-27. Head Removal
 Take care not to touch the nozzle side of the print head to be
installed and not to let dust or dirt adhere to the nozzles.
 When installing the carriage, take care not to scratch the nozzle
side.
A D J U S T M E N T
R E Q U I R E D
When replacing the print head, the following adjustment
procedures are required.
 Refer to “5.1.4.1 Print Head Adjustment” (p.212)
Head Holder
Screw (M3×6)
Loosen the screw
Print Head