Epson Stylus Pro 7600 - Disassembly and Assembly of Paper Feed Mechanism; PF Motor

EPSON Stylus Pro 7600/9600 Revision A
Disassembly & Assembly Disassembly and Assembly of Paper Feed Mechanism 185
4.4 Disassembly and Assembly of Paper Feed
Mechanism
4.4.1 PF Motor
1. Remove the L Side Cover. (p.163)
2. Disconnect the one connector cable of the PF Motor ASSY and take it out through the
hole in the L Side Frame.
(See Figure 4-50)
3. Remove the four screws securing the PF Motor Mounting Plate. (See Figure 4-51)
4. Move the PF Motor toward the printer body and remove the PF Motor by lifting the
gear side.
Figure 4-50. Removing the PF Motor ASSY Harness Connector.
Figure 4-51. Removing the PF Motor.
A D J U S T M E N T
R E Q U I R E D
After replacing the P_EDGE Sensor, the following adjustment
operation should be performed.
 “PF Motor Adjustment (p.214)”
Relay Connector
Clamp
PF Motor Mounting Plate securing screws x4