Epson Stylus Pro 7600 - Suction Fans

EPSON Stylus Pro 7600/9600 Revision A
Disassembly & Assembly Disassembly and Assembly of Paper Feed Mechanism 189
4.4.4 Suction Fans
1. Remove the Paper Guide L2. (p.168)
2. Remove the two screws (CP(W): M4 × 8) and one screw (CP(W): M4 × 40) securing the
fan duct, and then remove the fan duct.
3. Disconnect the fan connector and harness.
4. Remove the one screw (CP(W): M4
× 8) securing the fan, and remove the fan.
NOTE: The number of fans:
Stylus Pro 7600: 2
Stylus Pro 9600: 3
Figure 4-57. Suction Fan Mounting Position
Figure 4-58. Suction Fan Removal
C H E C K
P O I N T
When removing the right-side Suction Fan of Stylus Pro 7600, use a
short Phillips screwdriver to avoid interference with the
Maintenance Tank Holder.
Connector
Fan Fan Duct
Screws (CP(W): M4×8) ×2
Screw (CP(W): M4×8)
Screw (CP(W): M4×40)