Epson Stylus Pro 7600 - Flushing Box ASSY

EPSON Stylus Pro 7600/9600 Revision A
Disassembly & Assembly Disassembly and Assembly of Cleaning Mechanism 204
4.6.6 Flushing Box ASSY
1. Remove the R Side Cover. (p.160)
2. Remove the Paper Guide L2. (p.168)
3. From the printer body, pull off carefully the waste ink tube (thick) which connects the
Flushing Box ASSY to the Maintenance Tank.
4. Remove the one (CUPS: M3
× 6) screw securing the Flushing Box ASSY.
5. Take out the Flushing Box, while pulling off carefully the waste ink tube (thin) coming
from the Pump ASSY.
6. Remove the Flushing Box ASSY.
Figure 4-79. Removing the Flushing Box ASSY
After installing the Flushing Box ASSY, make certain by removing
the Paper Guide L2 that the waste ink tube (thick) is set securely on
the tube joint of the Maintenance Cartridge Holder.
C H E C K
P O I N T
Take off the ink tube (thick/thin) carefully so that ink will not spill
from the ink tube.
Waste ink tube
Waste ink tube (thin)
Waste ink tube (thick)
Flushing Box ASSY
Screw (CUPS: M3×6)